Prices for larger quantities may be obtained by contacting us or by clicking the RFQ below.
OEM quantities, more than 100 units or special instructions:
Special Comments
Quantity adjustment on next page
High Performance Pick and Hold Solenoid Driver Module is designed to avoid over heating of the solenoid coil once it is energized. It is done by applying an initial higher voltage to the solenoid coil to provide the
necessary force (torque) to pull the plunger in. Then, when seated, drops the voltage down to a level sufficient enough to maintain the plunger in the seated position.
The pick time and hold voltage are variable and set using the onboard potentiometers.
This product is RoHS complaint.
Performance Specifications
Parameter
Min
Typical
Max
Units
Supply Voltage
9
50
VDC
Peak Current
15
Amp
RMS Current
4
Amp
Command Range
3
50
VDC
Operating Temperature
0
50
Deg C
Storage Temperature
-40
125
Deg C
PWM Frequency
2.0
KHz
Performance Table
Input Signal
Pick Voltage
Pick Time
Hold Voltage
Hold Time
Pulse, 3-50 VDC
Equal to Power Supply Voltage
Variable, Set by a Trim Pot, 0 to 2,000 mS
Variable, Set by a Trim Pot, 0 to 100% of supply voltage
