Solenoid Driver PWM Module - solenoids, electromagnets, drivers and other industrial supplies at ElectroMechanicsOnline.com


Solenoids	Electromagnets	Electronics	Electric Cylinders	Magnets	Wire	Linear Motors	Springs

Search

only one keyword search term per box

Categories

Home

Solenoid Driver PWM Module
item #: ELSOPWM400

you may also consider

Solenoid Driver Module

ELSOSDM840

Power Driver Module, Proportional, Voltage Controlled

ELSOPWM950

Unit Price:
1-4 pieces:	$147.84
5-9 pieces:	$129.70
10-24 pieces:	$115.66
25-49 pieces:	$104.28
50-99 pieces:	$94.75
Prices for larger quantities may be obtained by contacting us or by clicking the RFQ below.
OEM quantities, more than 100 units or special instructions:




Special Comments

Quantity adjustment on next page

The Module is designed to enable the user to convert the input voltage in order to apply a different voltage to the solenoid or coil.

The output voltage to the coil can be varied to within 5% to 85% of the input voltage by adjusting an on board trim potentiometer.

The voltage within the above range can then be applied to the coil when a voltage (2 to 40 VDC) is applied to the trigger.

This is particularly useful when a solenoid requiring a relatively large amount of power needs to be turned on and off with a low power trigger voltage such as a TTL compatible signal.

Parameter	Min	Typical	Max	Units
Supply Input Voltage	8		40	VDC
Continuous Power			35	W
Continuous RMS Current			3	A
Momentary Current			20	A
Command (Trigger) Range	2		40	VDC
Command Input Resistance	50			KOhms
Operating Temperature	0		80	Deg C
Storage Temperature	-40		125	Deg C
PWM Frequency		20		KHz
Output to Input Voltage Ratio	5		85	%

Quantity adjustment on next page